Send document comments to nexus7k-feedback-doc@cisco.com
2-590
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SDV Messages
SCSI-TARGET-7
Error Message SCSI-TARGET-7-SCSI_TARGET_DISCOVERED: SCSI-target discovered
VSAN:[dec] FCID:[hex] prlisparm:[hex]
Explanation SCSI-target process discovered VSAN [dec] FCID [hex] prli service parameter [hex].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
SDV Messages
This section contains the SDV messages.
SDV-2
Error Message SDV-2-RANDNUM_FAIL: Random number generation failed
Explanation Random number generation failed. Process has to exit due to FIPS compliance.
Recommended Action No action is required.
SDV-3
Error Message SDV-3-ACL_CACHE_ERROR: ACL CACHE ERR, Trying to prog with no interface
list
Explanation A Null interface list was generated for a ACL entry.
Recommended Action No action is required.
Error Message SDV-3-ACL_ERROR: ACL API, [chars], failed with error [hex]
Explanation SDV invoked ACL API and received the error code. [chars] describes the API and
0x[hex] specifies the error.
Recommended Action No action is required.
Error Message SDV-3-ALLOC_FAILED: Failed for type [dec] size [dec]
Explanation The SDM process could not allocate heap memory. [dec] is the memory type and [dec]
is the size of memory.
Recommended Action No action is required.