Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-299
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IPSEC Messages
Error Message IPS_SB_MGR-SLOT#-4-NODE_NOT_COMPAT_WITH_CURRENT: svc-node[dec] image
is not compatible with current node image
Explanation The new svc image is not compatible with the svc image currently running on the node.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IPS_SB_MGR-SLOT#-4-NODE_NOT_COMPAT_WITH_SUP: svc-node[dec] image is
not compatible with system image
Explanation The svc image on the node is not compatible with the supervisor image.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
IPS_SB_MGR-SLOT#-6
Error Message IPS_SB_MGR-SLOT#-6-SBMGR_EVENT: Sbmgr event: [chars]
Explanation This is an event log of sb_mgr relating to a port/node.
Recommended Action No action is required.
IPSEC Messages
This section contains the IPSEC messages.
IPSEC-2
Error Message IPSEC-2-IPSEC_INIT: IPSec initialization of [chars] [chars]
Explanation IPSec initialization has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IPSEC-2-IPSEC_SPD_OVERFLOW_DUE_TO_ACL: SPD Overflow on interface due
to IP ACL [chars] bound to crypto map [chars] [dec]
Explanation Modifying IP ACL caused Security Policy Database on the interface to overflow, IP
ACL filter not applied to security policy database.
Recommended Action Undo IP ACL change.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English