Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-783
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
VEDB_MGR Messages
VEDB_MGR Messages
This section contains the VEDB_MGR messages.
VEDB_MGR-2
Error Message VEDB_MGR-2-MALLOC_ERROR: Size [dec] bytes
Explanation The VEDB library could not allocate enough memory.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
VEDB_MGR-6
Error Message VEDB_MGR-6-EXITING: Exited due to [chars]
Explanation The VEDB library has exited due to [char]. The process has probably been restarted
automatically.
Recommended Action No action is required.
Error Message VEDB_MGR-6-SERVICE_UP: Initialized [chars]
Explanation The VEDB library is up and ready to accept client requests The service was initialized
in [char] mode.
Recommended Action No action is required.
VES-SLOT# Messages
This section contains the VES-SLOT# messages.
VES-SLOT#-4
Error Message VES-SLOT#-4-LOG_WARNING_VES_CONFIG_TOO_BIG: Volume [chars]
configuration too large to virtualize
Explanation The VES maximum volume configuration was exceeded. Volume will be virtualized by
the cpp.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English