Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-573
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
RLIR Messages
Error Message RLIR-2-INIT_FAILED: RLIR Init failed: [chars]
Explanation RLIR Init failed: [chars].
Recommended Action No action is required.
Error Message RLIR-2-LINK_INCIDENT: Interface [chars] [Port [hex]], Link Status:
[chars], Link Status Reason: [chars]
Explanation RLIR module detected an unintentional Link Incident.
Recommended Action No action is required.
Error Message RLIR-2-MALLOC_FAILED: RLIR Malloc failed: [chars]
Explanation RLIR Malloc failed: [chars].
Recommended Action No action is required.
Error Message RLIR-2-MTS_FAILED: RLIR MTS operation failed: [chars]: [chars]
Explanation RLIR MTS operation failed: [chars] [chars].
Recommended Action No action is required.
Error Message RLIR-2-PSS_FAILED: RLIR PSS operation failed: [chars]: [chars]
Explanation RLIR PSS operation failed: [chars] [chars].
Recommended Action No action is required.
RLIR-6
Error Message RLIR-6-SYSLOG_INFO: RLIR Syslog info: [chars]
Explanation RLIR Syslog info: [chars].
Recommended Action No action is required.
Error Message RLIR-6-SYSLOG_STATUS: RLIR Syslog status: [chars]: [chars]
Explanation RLIR Syslog status: [chars] [chars].
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English