Send document comments to nexus7k-feedback-doc@cisco.com
2-825
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
XBAR Messages
Error Message XBAR-5-ARB_INIT_PORT_FAIL: Arbiter reported failure to register port
[dec] in group [dec] return_code [hex] ([chars]).
Explanation The supervisor has experienced an arbiter setup failure .
Recommended Action No action is required.
Error Message XBAR-5-ARBITER_INIT_FAILURE: Re-initializing Arbiter.
Explanation The supervisor has experienced an arbiter setup failure .
Recommended Action No action is required.
Error Message XBAR-5-ARBITER_INIT_FAILURE: Re-initializing Arbiter. [chars] [chars]
module %i
Explanation The supervisor has experienced an arbiter setup failure .
Recommended Action No action is required.
Error Message XBAR-5-MOD_CONNECTION_REATTEMPT: Re-attempting XBAR connection with
module [dec]
Explanation The module has experienced a setup failure on connecting the module to the fabric.
Recommended Action Collect more informations about XBAR component Use command 'show xbar
internal event-history module <module id>'. Power cycling the module may recover.
Error Message XBAR-5-XBAR_ENABLE_FPOE_DB_FAILURE: XBAR [chars] enabling FPOE-DB
mode failed
Explanation The supervisor failed to enable FPOE-DB mode in fabric. The supervisor is going to
reboot. If you have two supervisor modules, a switchover will occur.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_INIT_FAIL: Xbar [[dec].[dec]] reported failure durinig
intialization return_code [hex] ([chars]).
Explanation The supervisor has experienced an crossbar setup failure.
Recommended Action No action is required.
Error Message XBAR-5-XBAR_INIT_FAILURE: XBAR [chars] initialization failed
Explanation The supervisor has experienced a fabric initialization failure. The supervisor is going
to reboot. If you have two supervisor modules, a switchover will occur.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
