EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #802 background imageLoading...
Page #802 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-764
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message URIB-3-ASSERT_ERROR Format: %s:%d: Assertion \%s\ failed.
Explanation An internal software error has occurred. An assertion held to be true failed.
Parameters: Filename, Line number, Expression ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message URIB-3-AVLADD_ERROR Format: Could not add %s (0x%08x) to the %s avl
Explanation URIB was unable to add a piece of data to an AVL data structure.
Parameters: Data item, Memory address, Data structure ...
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message URIB-3-AVLINIT_ERROR Format: Could not init %s avl for VRF %s
Explanation URIB was unable to correctly initialize an AVL data structure.
Parameters: AVL name, VRF-name ...
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message URIB-3-CMI_MTSSEND_FAILURE Format: mts_send failure for client %s: %s
Explanation URIB was unable to send an MTS message to a particular client
Parameters: Client name, Error ...
Recommended Action Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' CLI command.
Error Message URIB-3-CMI_PAYLOAD_CONV_ERR Format: CMI payload conversion error
failure from %s order to %s order
Explanation The cmi payload conversion did not occur successfully.
Parameters: order, order ...
Recommended Action No action is required.
Error Message URIB-3-COPY_ERROR Format: Could not copy %s for %s/%d
Explanation A error was encountered during route optimization. The system may run into more
errors because of this problem.
Recommended Action No action is required.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals