Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-304
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IPV6 Messages
Error Message IPv6-3-FRAME_LENGTH_LONG Format: Frame length: %d greater than
maximum IPv6 payload size for packet received on interface %s
Explanation The packet has too big frame length, dropped.
Recommended Action No action is required.
Error Message IPv6-3-FRAME_LENGTH_SHORT Format: Frame length: %d less than IPv6
payload length: %d for packet received on interface %s
Explanation The packet has invalid frame length, dropped.
Recommended Action No action is required.
Error Message IPv6-3-GET_PIB_FAILED Format: %s failed in %s
Explanation IPv6 could not find client's PIB handle.
Recommended Action No action is required.
Error Message IPV6-3-INIT_FAILED: Initialization failed. Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurred while
initializing the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
debug the specified component.
Error Message IPv6-3-INVALID_VERSION Format: Invalid IPv6 version: %d for packet
received on interface %s
Explanation The packet has invalid protocol version field, dropped.
Recommended Action No action is required.
Error Message IPv6-3-IPV6_API_FAILED Format: %s failed in %s
Explanation A component API call has failed in IPv6.
Recommended Action No action is required.
Error Message IPv6-3-IPV6_CV_INIT Format: Couldn't init cond var %s
Explanation IPv6 process has failed to initialize a conditional-variable resource.
Parameters: Thread Name ...
Recommended Action Dump core, and then restart component.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English