Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-675
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-2-CFGWRITE_ABORTED: Configuration copy aborted.
Explanation A configuration copy has failed.
Recommended Action Verify the other syslog messages printed correct the problem, and try again.
Error Message SYSMGR-2-CFGWRITE_ABORTED_DIR: Unable to open the configuration
directory. Aborting configuration copy.
Explanation The destination location for the startup-config could not be found.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.
Error Message SYSMGR-2-CFGWRITE_ABORTED_INIT: Unable to initialize the
configuration directory (error-id [hex]). Aborting configuration copy.
Explanation An attempt to copy the running-config to startup-config has failed because the old data
could not be removed.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.
Error Message SYSMGR-2-CFGWRITE_ABORTED_LABEL: Unable to label the new
configuration (error-id [hex]). Aborting configuration copy.
Explanation An attempt to copy the running-config to startup-config has failed because the new
startup-config could not be stamped.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.
Error Message SYSMGR-2-CFGWRITE_ABORTED_LOCK: Unable to lock the configuration
(error-id [hex]). Aborting configuration copy.
Explanation An attempt to copy the running-config to startup-config has failed because the system
could not lock the required configuration items.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-CFGWRITE_ABORTED_LOG: Unable to open a log file for the new
configuration: [chars] (error-id [hex]). Aborting configuration copy.
Explanation An attempt to copy the running-config to startup-config has failed because a log file
could not be created.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English