Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-261
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ILC-SPAN Messages
Error Message IKE-4-UNKNOWN_PAYLOAD: IKEv2 received message (from [chars]) with
un-recognized payload ([chars])
Explanation The system has received an invalid payload.
Recommended Action No action is required.
Error Message IKE-4-UNSUPPORT: [chars] is not supported (message from [chars])
Explanation Received something unsupported.
Recommended Action No action is required.
IKE-6
Error Message IKE-6-POLL_START_DONE: IKE is exiting since it is not enabled
Explanation IKE is exiting since it is not enabled in the configuration.
Recommended Action No action is required.
ILC-SPAN Messages
This section contains the ILC-SPAN messages.
ILC-SPAN-3
Error Message ILC-SPAN-3-ERROR: [chars]
Explanation Ilc_span_mgr has detected an error.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
ILC_HELPER Messages
This section contains the ILC_HELPER messages.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English