Send document comments to nexus7k-feedback-doc@cisco.com
2-591
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SDV Messages
Error Message SDV-3-ASSERTION_FAILED: [chars]:[dec]
Explanation The SDM process has hit an assert condition at file [chars] line number [dec].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SDV-3-AUTO_FAILOVER_ERROR: [chars]
Explanation SDV Virtual-device failed to auto-failover due to [chars].
Recommended Action No action is required.
Error Message SDV-3-BCAST_NOT_SUPPORTED: Broadcast attribute will be ignored for
SDV devices
Explanation Broadcast attribute will be igored for SDV devices.
Recommended Action No action is required.
Error Message SDV-3-ENQUEUE_EVENT_FAIL: Unable to enqueue event into state machine
Explanation The system is unable to enqueue event into state machine.
Recommended Action No action is required.
Error Message SDV-3-FCID_REWRITE_REQUEST_TO_ACL_FAILED: fcid rewrite [chars]
request vsan [dec] vdev_id [dec] failed:[chars].
Explanation This happens when either after SDV retried the request a few times or ACL experienced
error while processing the request.
Recommended Action No action is required.
Error Message SDV-3-INIT_FAIL: [chars]
Explanation The SDM process init has failed due to [chars].
Recommended Action No action is required.
Error Message SDV-3-INTERNAL_ERR: [chars]
Explanation The SDM process encountered an internal error due to [chars].
Recommended Action No action is required.
To Next Page
Loading...
