Send document comments to nexus7k-feedback-doc@cisco.com
2-810
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
VRRP_ENG Messages
VRRP_ENG-2
Error Message VRRP_ENG-2-ALLOC_MEMORY: Memory allocation failed
Explanation The service failed to allocate a block of dynamic memory.
Recommended Action No action is required.
Error Message VRRP_ENG-2-INVALID_CONFIG: Cannot start the VR[chars] [dec] on the
interface [chars]. Invalid IP configuration. Reason: [chars]
Explanation The specified VR on interface [chars] is enabled but the IP configuration is not valid
because of [chars].
Recommended Action Show interface to check that the IP address of the interface is configured and
it is in the same subnet of the virtual router address.
Error Message VRRP_ENG-2-VR_FAILURE: Error in VR[chars] [dec] interface [chars].
Going to init state
Explanation The VR [dec] on the interface [chars] is in init state for an internal error.
Recommended Action Show interface to check the status of the interface, show configuration, status
and statistics of the specified virtual router, enable the VRRP debug and shut/ no shut the specified
virtual router.
VRRP_ENG-3
Error Message VRRP_ENG-3-INIT_FAILED: Initialization failed. Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurred while
initializing the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
debug the specified component.
VRRP_ENG-4
Error Message VRRP_ENG-4-BAD_ADV: VR[chars] ID [dec] on interface [chars] bad
advertisement received: reason [chars]
Explanation The virtual router specified has received an invalid advertisement.
Recommended Action Check that all VRRP nodes have the same configuration.
To Next Page
Loading...
Need help?
General
