Send document comments to nexus7k-feedback-doc@cisco.com
2-232
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FWM Messages
Error Message FWM-2-STM_LEARNING_RE_ENABLE: Re enabling dynamic learning on all
interfaces
Explanation Reenabling learning on all interfaces after disable period expired.
Recommended Action No action is required.
Error Message FWM-2-STM_LIMIT_REACHED: [chars]
Explanation The system station table reached its capacity - no further MAC addresses could be
programmed - administration intervention may be required to avoid this problem in future.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message FWM-2-STM_LOOP_DETECT: [chars]
Explanation The system detected loops in the network - administration intervention may be required
to avoid this problem in future.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message FWM-2-STM_MCAST_PROG_RE_ENABLE: Re enabling programming multicast
entries
Explanation Reenabling programming new multicast entries because number of entries reached
below threshold.
Recommended Action No action is required.
FWM-3
Error Message FWM-3-FCFIB_ERR: [chars]
Explanation Fcfib has detected an error.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message FWM-3-FCFIB_NO_MEM: Out of memory
Explanation Fcfib does not have enough memory to continue proper operation.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
To Next Page
Loading...
