Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-327
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ISNS Messages
Error Message ISIS-6-SYSMAN_CLEANUP Format: Terminated by SYSMAN cleanup signal ;
Explanation: IS-IS has been signaled to exit.
Explanation The system has detected an error.
Recommended Action No action is required.
Error Message ISIS-6-UNK_NLPID Format: Unrecognized NLP ID %02X from %s%s
Explanation IS-IS has received a packet with an NLPID which it does not recognize. The packet will
be dropped.
Parameters: NLP Id, Interface Name, Source Destination Addr ...
Recommended Action No action is required.
Error Message ISIS-6-UNK_PDU Format: Unrecognized PDU type %d from %s%s
Explanation IS-IS has received a packet of a type which it does not recognize. The packet will be
dropped.
Parameters: PDU Type, Source Addr, Destination Addr ...
Recommended Action No action is required.
ISNS Messages
This section contains the ISNS messages.
ISNS-2
Error Message ISNS-2-ISNS_CFS_OPERATION_FAILED: iSNS CFS [chars] failed
Explanation ISNS CFS operation failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message ISNS-2-ISNS_INIT: iSNS initialization of [chars] [chars]
Explanation ISNS initialization has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
IVR Messages
This section contains the IVR messages.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English