Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-69
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BOOTVAR Messages
Error Message BOOTVAR-3-LOAD_VERIFY_LIB_FAILED: Fetching library [chars] failed,
reason=[chars]
Explanation The system has failed to load bootvar that is specified in the verification library.
Recommended Action No action is required.
Error Message BOOTVAR-3-MODULE_LOCK_FAIL: Unable to get module lock, please don't
reload <error-id:[hex]>
Explanation The system is unable to acquire modlock to prevent the user to reload
duringautosynchronization.
Recommended Action No action is required.
Error Message BOOTVAR-3-NEIGHBOR_REJECT_AUTOCOPY: auto-copy failed - not supported
by neighbor supervisor.
Explanation The autocopy has failed because it is not supported by the standby supervisor module.
Recommended Action No action is required.
Error Message BOOTVAR-3-VERIFY_FAILED: Image [chars] for bootvar [chars]
verification failed, reason=[chars]
Explanation The image set for this bootvar has failed the verification process.
Recommended Action Check reason to determine actions.
BOOTVAR-5
Error Message BOOTVAR-5-AUTOCOPY_DID_NOT_START: Autocopy of file [chars] to standby
did not start. [chars] (Error-id: [hex])
Explanation An autocopy of the file could not start because the remote copy location does not exist.
Recommended Action No action is required.
Error Message BOOTVAR-5-AUTOCOPY_SUCCEED: auto-copy of file [chars] to standby
supervisor succeed
Explanation The autocopy of the file has succeeded. The image integrity has been verified by the
standby supervisor module.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English