Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-158
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETH_PORT_CHANNEL Messages
Error Message ETH-PORT-SEC-5-ETH_PORT_SEC_HOST_DELETION: Host [chars] bound to
secure port [chars] in Vlan [dec] has been removed
Explanation A host has been removed.
Recommended Action No action is required.
ETH_PORT_CHANNEL Messages
This section contains the ETH_PORT_CHANNEL messages.
ETH_PORT_CHANNEL-1
Error Message ETH_PORT_CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed
[[chars]]
Explanation Module configuration failed.
Recommended Action Module will be automatically reset.
Error Message ETH_PORT_CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec])
Explanation Not enough memory.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for
[chars] [[chars]]
Explanation Parameter mapping failed.
Recommended Action Specified service has failed; check its status.
Error Message ETH_PORT_CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast
[chars]: [chars]
Explanation The system has failed to send a multicast message to all modules, usually because some
module went down.
Recommended Action Run show port channel consistency to check consistency.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English