Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-713
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-6-HANDSHAKE_VERIFYING_DONE: Handshake verification done from
service [chars].
Explanation The system has detected an error.
Recommended Action No action is required.
Error Message SYSMGR-6-LC_UPG_DEBUG: LC DEBUG: [chars]
Explanation Linecard upgrade debug message.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-6-RLIMIT_INFO: rlimit of service [chars]([dec]) = %llu
Explanation The system has detected an error.
Recommended Action No action is required.
Error Message SYSMGR-6-SERVICE_STARTED: Service [chars] in vdc [dec] started with
PID([dec]).
Explanation The The system Manager is starting a service. This message is for debugging purposes
only.
Recommended Action No action is required.
Error Message SYSMGR-6-SERVICE_SUCCESS_EXIT: Service [chars] (PID [dec]) has
successfully exited with exit code [chars] ([dec]).
Explanation A service has successfully exited its execution.
Recommended Action No action is required.
Error Message SYSMGR-6-SRV_ENQUEUED_FOR_START: Conditional service [chars] started
by sap [dec] has been enqueued for start.
Explanation The system has detected an error.
Recommended Action No action is required.
Error Message SYSMGR-6-SRVSCOPE_COMPLETED: Completed execution for scope [chars].
Explanation This message is for Cisco TAC debugging. This is not a problem or malfunction.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English