Cisco AP775A - Nexus Converged Network Switch 5010 - Diag_Port_Lb-2

Send document comments to nexus7k-feedback-doc@cisco.com
2-115
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DIAG_PORT_LB Messages
Error Message DIAG_PORT_LB-2-PROC_INIT_FAILURE: [chars]([dec]) [chars]
Error:[chars]
Explanation Port Loopback test process failed in process initialization.
Recommended Action No action is required.
Error Message DIAG_PORT_LB-2-REWRITE_ENGINE_LOOPBACK_TEST_FAIL: Module:[dec]
Test:RewriteEngine Loopback failed [dec] consecutive times. Faulty module:[chars]
affected ports:[chars] Error:[chars]
Explanation The Rewrite Engine Loopback test has failed on the module consecutively.
Recommended Action No action is required.
Error Message DIAG_PORT_LB-2-VLAN_ERROR: [chars]([dec]) [chars] Error:[chars]
Explanation Port Loopback test process failed to get Diagnostic VLAN information.
Recommended Action No action is required.
DIAG_PORT_LB-3
Error Message DIAG_PORT_LB-3-DIAG_FWD_PATH_SETUP_FAILURE: [chars]. Module:[dec]
Error:[chars].
Explanation Forwarding path setup for port loopback tests failed.
Recommended Action No action is required.
Error Message DIAG_PORT_LB-3-DIAG_PKT_SEND_FAILURE: [chars]([dec]) [chars].
Error:[chars]
Explanation Port Loopback test process failed to send loopback packets.
Recommended Action No action is required.
Error Message DIAG_PORT_LB-3-FSM_LIB_ERROR: [chars]([dec]) [chars]. Error:[chars]
Explanation Port Loopback test process failed in MTS API.
Recommended Action No action is required.