Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-73
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
CDP Messages
CALLHOME-6
Error Message CALLHOME-6-NONCRIT_EVENT: [chars]
Explanation A noncritical Call Home event [chars] occurred.
Recommended Action If you have configured your e-mail address to receive Call Home notifications,
check your e-mail for more details about this Call Home event. If Call Home was not enabled,
execute commands relevant to the callhome event to get more information about the error.
CDP Messages
This section contains the CDP messages.
CDP-2
Error Message CDP-2-INITFAIL: CDP Daemon Initialization failed: [chars]
Explanation CDP daemon initialization has failed. [chars] explains the reason for the failure.
Recommended Action No action is required.
CDP-3
Error Message CDP-3-ALLOCFAIL: Heap Memory allocation failed: [chars]
Explanation The CDP daemon is out of dynamic memory. [chars] specifies the context where the
failure occurred.
Recommended Action No action is required.
Error Message CDP-3-GENERROR: [chars]
Explanation The CDP daemon encountered a generalerror thatdoes not fall in any of the above
categories. [chars] describes the error and its context.
Recommended Action No action is required.
Error Message CDP-3-MCASTBINDFAIL: Failed to bind for CDP multicast address on
interface [hex] - [chars]
Explanation An attempt to register for packets destined to the CDP multicast address failed. [dec]
identifies the interface and [char] identifies the reason.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English