Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-326
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ISIS Messages
ISIS-6
Error Message ISIS-6-JUMBO_PDU Format: Drop %hu bytes jumbo PDU with %hu bytes
buffer from %s%s
Explanation IS-IS has received a packet that exceeds the maximum supported size. The packet will
be dropped.
Parameters: Packet Length,PDU Maximum Size, Interface Name, Source Destination Addr ...
Recommended Action No action is required.
Error Message ISIS-6-MODE_NO_FUNC Format: No callback function registered for %s in
%s mode
Explanation IS-IS encountered a problem where no callback function has been registered in the
given mode
Parameters: Function name, Mode name ...
Recommended Action No action is required.
Error Message ISIS-6-SEQWRAP_HOLDDOWN Format: Sequence number wraparound holddown
timer expired - enable process
Explanation The correct amount of time has elapsed after an LSP's sequence number wrapped so
that IS-IS can resume normal operation.
Recommended Action No action is required.
Error Message ISIS-6-SHUTDOWN_FAILURE Format: Shutdown failure. Failed to %s - %s
; Parameters: Reason, Reason Code ...
Explanation IS-IS request to system manager for permission to shutdown was declined.
Recommended Action No action is required.
Error Message ISIS-6-START Format: Process start. Reason - %s
Explanation ISIS procss start with specified reason
Parameters: Reason ...
Recommended Action No action is required.
Error Message ISIS-6-STOP Format: Process stop. Reason - %s
Explanation ISIS procss stop with specified reason
Parameters: Reason ...
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English