Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-456
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM Messages
Error Message PIM-6-NEGATIVE_PREFIX Format: Group prefix %s/%d from RP %s has
negative-bit set, ignore group entry
Explanation The RP is advertising a group range to be in dense-mode. This implementation only
supports sparse-mode so the group entry will be igored.
Parameters: Group Address, Mask length, RP Address ...
Recommended Action No action is required.
Error Message PIM-6-RESERVE_LIMIT_WARNING Format: Exceeded 80% of the reserve-limit
for VRF %s
Explanation Exceeded 80% of the reserve-limit for VRF
Parameters: VRF ...
Recommended Action No action is required.
Error Message PIM-6-RESTART_SHUTDOWN Format: PIM shutting self down via restart
command
Explanation PIM process is shutting itself down due to the restart command.
Recommended Action No action is required.
Error Message PIM-6-SHUTDOWN Format: Shutting down PIM process
Explanation PIM received a shutdown request.
Recommended Action No action is required.
Error Message PIM-6-SHUTDOWN_SELF Format: PIM shutting self down
Explanation PIM process is shutting itself down.
Recommended Action No action is required.
Error Message PIM-6-STATE_LIMIT_WARNING Format: Exceeded 80% of the state-limit for
VRF %s
Explanation Exceeded 80% of the state-limit for VRF
Parameters: VRF ...
Recommended Action No action is required.
Error Message PIM-6-UNKNOWN_OPC Format: Received unknown mts opcode %d
Explanation PIM process received unknown Interprocess message, dropped.
Parameters: MTS Opcode ...
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English