Send document comments to nexus7k-feedback-doc@cisco.com
2-122
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DIAGMGR Messages
Error Message DIAGCLIENT-5-ONDEMAND_FAIL: Module <[dec]> Test <[chars]> has failed
in Test_Iteration <[dec]>
Explanation The specified test has reported FAILURE in this Iteration.
Recommended Action No action is required.
Error Message DIAGCLIENT-5-ONDEMAND_SUCCESS: Module <[dec]> Test <[chars]> has
completed successfully in Test_Iteration <[dec]>
Explanation The specified test has reported SUCCESS in this Iteration.
Recommended Action No action is required.
DIAGMGR Messages
This section contains the DIAGMGR messages.
DIAGMGR-2
Error Message DIAGMGR-2-MTS_SEND_FAILURE: MTS send failed, mts_opc: [chars], dest
slot: [dec], dest SAP: [dec], error-id: [hex]
Explanation MTS send reports failure.
Recommended Action No action is required.
Error Message DIAGMGR-2-PSS_DELETE_FAILURE: Read from PSS failed on Module <[dec]>
Explanation Read operation from PSS store failed.
Recommended Action No action is required.
Error Message DIAGMGR-2-PSS_WRITE_FAILURE: Write to PSS failed on Module <[dec]>
Explanation Write operation on PSS store failed.
Recommended Action No action is required.
To Next Page
Loading...
