Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-571
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
RIP Messages
Error Message RIP-4-VALIDATE_ENTRY Format: %s
Explanation A route entry in an incoming response packet is invalid
Parameters: Error ...
Recommended Action No action is required.
Error Message RIP-4-VALIDATE_SRC Format: %s %s
Explanation An incoming packet has failed validation
Parameters: Failure Reason, Interface Name ...
Recommended Action No action is required.
RIP-5
Error Message RIP-5-TOO_BIG_KEY_SIZE Format: Authentication key %s is > 16
characters in keychain %s
Explanation Authentication key size is > 16 characters.
Parameters: Authentication Key, Keychain Name ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message RIP-5-U6RIB_API_FAILURE Format: Failed to %s routes %s U6RIB
Explanation An API call to U6RIB has failed
Parameters: Event, To/From ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message RIP-5-URIB_API_FAILURE Format: Failed to %s routes %s URIB
Explanation An API call to URIB has failed
Parameters: Event, To/From ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English