Send document comments to nexus7k-feedback-doc@cisco.com
2-181
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
EUREKA_USD Messages
Error Message ETHPORT-5-IF_TX_FLOW_CONTROL: Interface [chars], operational Transmit
Flow Control state changed to [chars]
Explanation Operational transmit flow control has changed when link came up.
Recommended Action No action is required.
Error Message ETHPORT-5-IF_UP: Interface [chars] is up [chars]
Explanation The interface is up in the mode specified, if applicable.
Recommended Action No action is required.
Error Message ETHPORT-5-SPEED: Interface [chars], operational speed changed to
[chars]
Explanation Operational speed has changed when link came up.
Recommended Action No action is required.
Error Message ETHPORT-5-STORM_CONTROL_ABOVE_THRESHOLD: Traffic in port [chars]
exceeds the configured threshold [chars]
Explanation Traffic on specified port is beyond the configured storm-control threshold, and the
excess traffic is being dropped.
Recommended Action Identify source of traffic storm.
Error Message ETHPORT-5-STORM_CONTROL_BELOW_THRESHOLD: Traffic in port [chars] has
fallen below the configured threshold [chars]
Explanation Traffic on specified port has returned to within configured storm-control threshold.
Recommended Action No action is required.
EUREKA_USD Messages
This section contains the EUREKA_USD messages.
EUREKA_USD-3
Error Message EUREKA_USD-3-MSG1: [chars]
Explanation Eureka log message.
Recommended Action No action is required.