Send document comments to nexus7k-feedback-doc@cisco.com
2-283
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IPS Messages
Error Message IPS-3-FCIP_FTA_RETRY_ERROR: [chars] retries [dec] FC oxid [hex] My
oxid [hex] State [chars] Event [chars] CH FCID: [hex] CHI: [hex] CU FCID [hex]
CUI: [hex] DA [hex] VSAN: [dec]
Explanation FTA Command timed out.
Recommended Action No user action is required.
Error Message IPS-3-IPS_CRYPTO_FIPS_FAILED: IPS module [dec] has failed FIPS tests.
FIPS info - [chars]
Explanation FIPS error occurred in the IPS module.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IPS-3-IPS_EGRESS_PERR: Parity error on dma-bridge egress. Count:
[dec]
Explanation Parity error occurred in dma-bridge egress direction.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IPS-3-IPS_FIPS_TEST_FAILED: IPS FIPS compliance test failed
Explanation IPS FIPS compliance test failed.
Recommended Action No action is required.
Error Message IPS-3-IPS_INGRESS_PERR: Parity error on dma-bridge ingress. Count:
[dec]
Explanation Parity error occurred in dma-bridge ingress direction.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IPS-3-ISLB_CFS_CLEAR_FAILED: [chars]
Explanation An error has occurred while clearing the CFS lock. The reason for the failure : [chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.