Send document comments to nexus7k-feedback-doc@cisco.com
2-418
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
NPV Messages
Error Message NPV-3-F_RJT_SENT: [chars]
Explanation NPV process sent an F_RJT frame.
Recommended Action No action is required.
Error Message NPV-3-FC2_SEND_FAILED: [chars]
Explanation NPV process could not send an FC2 message.
Recommended Action No action is required.
Error Message NPV-3-INTERNAL_ERROR: Internal error: [chars]
Explanation NPV process encountered a generalerror thatdoes not fall in any of the categories.
[chars] describes the error and its context.
Recommended Action No action is required.
Error Message NPV-3-LCP_PROGRAMMING_FAILED: [chars]
Explanation LCP programming request initiated by the NPV process has failed.
Recommended Action No action is required.
Error Message NPV-3-LOCK_FAILED: [chars]
Explanation An error has occurred while acquiring the lock. The reason for the failure : [chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message NPV-3-LS_RJT_RCVD: [chars]
Explanation NPV process received an LS_RJT frame.
Recommended Action No action is required.
Error Message NPV-3-LS_RJT_SENT: [chars]
Explanation NPV process sent an LS_RJT frame.
Recommended Action No action is required.
Error Message NPV-3-MALLOC_FAILED: [chars]
Explanation NPV process could not allocate enough memory.
Recommended Action No action is required.
To Next Page
Loading...
