Cisco AP775A - Nexus Converged Network Switch 5010

Send document comments to nexus7k-feedback-doc@cisco.com
2-419
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
NPV Messages
Error Message NPV-3-MERGE_ACTIVATION_FAILED: [chars]
Explanation An error has occurred while activating merged configuration. The reason for the failure
: [chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message NPV-3-MERGE_FAILED: [chars]
Explanation An error has occurred while merging the configuration. The reason for the failure :
[chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message NPV-3-MTS_SEND_FAILED: [chars]
Explanation NPV process could not send an MTS message.
Recommended Action No action is required.
Error Message NPV-3-NPIV_DISABLE_FAILED: [chars]
Explanation NPIV feature could not be disabled.
Recommended Action No action is required.
Error Message NPV-3-NPV_CFS_IPV4_ENABLE_FAILED: CFS IPv4 distribution enable failed
because [chars]
Explanation NPV CFS distRIBution might not work. Try enabling it again on the command line.
Make sure cfs distRIBution is enabled.
Recommended Action No action is required.
Error Message NPV-3-PORT_BRINGUP_FAILED: [chars]
Explanation NPV process has failed to bring up the port.
Recommended Action No action is required.
Error Message NPV-3-PORT_REINIT_FAILED: [chars]
Explanation Port reinit request initiated by the NPV process has failed.
Recommended Action No action is required.