Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-420
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
NPV Messages
Error Message NPV-3-UNLOCK_FAILED: [chars]
Explanation An error has occurred while releasing the lock. The reason for the failure : [chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
NPV-4
Error Message NPV-4-NPV_NPIV_NOT_ENABLED_ON_UPSTREAM_SWITCH: [chars]
Explanation The external interface has failed to come because the NPIV feature is not enabled on
the upstream switch.
Recommended Action Verify and enable NPIV feature in upstream switch.
Error Message NPV-4-NPV_PORT_VSAN_MISMATCH_ON_UPSTREAM_LINK: [chars]
Explanation The external interface has failed to come because the upstream port VSAN has a
mismatch with the upstream switch.
Recommended Action Make sure the port VSAN is the same on both sides of this external link.
NPV-5
Error Message NPV-5-ASSERTION_FAILED: Unexpected assertion failure in File [chars]
at Line [dec]
Explanation An assertion has failed in NPV code.
Recommended Action No action is required.
Error Message NPV-5-FLEXATTACH_VPWWN_AUTO_ASSIGNED: A virtual port WWN [chars] has
been automatically assigned to interface [chars]
Explanation The virtual port WWN will be used as port WWN for devices logging in on this
interface.
Recommended Action No action is required.
Error Message NPV-5-FLEXATTACH_VPWWN_MANUALLY_ASSIGNED: A virtual port WWN [chars]
has been manually assigned to interface [chars]
Explanation The virtual port WWN will be used as port WWN for devices logging in on this
interface.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English