Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-243
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ICMPV6 Messages
Error Message HSRP_ENGINE-6-STANDBYROUTERPRIORITYCHANGE: Interface [chars] [chars]
Grp [dec] Standby router priority changed to [dec]
Explanation The priority of the Standby router for the group has changed.
Recommended Action No action is required.
Error Message HSRP_ENGINE-6-STATECHANGE: [chars] Grp [dec] state move to [chars]
Explanation The router has changed its state.
Recommended Action No action is required.
Error Message HSRP_ENGINE-6-STATECHANGE2: [chars] Grp [dec] state moving from
[chars]
Explanation The router has changed its state.
Recommended Action No action is required.
Error Message HSRP_ENGINE-6-TIMER: Interface [chars] [chars] Grp [dec] [chars]
timer changed to [dec] [chars]
Explanation The hello/hold timer value for the HSRP group has changed.
Recommended Action No action is required.
Error Message HSRP_ENGINE-6-VIPLEARN: Interface [chars] [chars] Grp [dec] learnt
virtual ip address [chars]
Explanation The local router has learned virtual ip address from the incoming HSRP packet.
Recommended Action No action is required.
ICMPV6 Messages
This section contains the ICMPV6 messages.
ICMPV6-2
Error Message ICMPv6-2-MALLOC_FAILED Format: malloc() failed for allocating %s in
%s()
Explanation ICMPv6 process is out of heap memory. This could be due to temporary increase in the
number of static or dynamic Neighbor Cache Entries(NCEs) to a very high value.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English