Send document comments to nexus7k-feedback-doc@cisco.com
2-526
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT-RESOURCES Messages
Error Message PORT-CHANNEL-7-START_STANDBY: started in standby mode
Explanation The system has detected a manager started in standby mode.
Recommended Action No action is required.
Error Message PORT-CHANNEL-7-START_STATEFUL: started statefully
Explanation The system has detected a manager started with running configuration.
Recommended Action No action is required.
Error Message PORT-CHANNEL-7-START_STATELESS: started statelessly
Explanation The system has detected a manager started with startup configuration.
Recommended Action No action is required.
PORT-RESOURCES Messages
This section contains the PORT-RESOURCES messages.
PORT-RESOURCES-3
Error Message PORT-RESOURCES-3-PRM_MSG_SEND_FAILURE: failed to send [chars] to sap
[dec]: [chars]
Explanation The system has failed to send a message.
Recommended Action No action is required.
PORT-RESOURCES-5
Error Message PORT-RESOURCES-5-INVALID_PORT_ACTIV_PKG_LICENSE_FILE_INSTALLED:
Invalid on demand port activation license file is installed for module [dec]
Explanation Interfaces may not acquire port activation licenses during installation.
Recommended Action Install a valid port activation license file.