EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-125
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DMM-SLOT# Messages
Error Message DIAGMGR-5-INTRVL_INCORRECT: Monitoring Interval is less than minimum
of [dec] seconds required for Module <[dec]> test <[chars]>
Explanation Health Monitoring cannot be enabled for the specified test because the interval for the
test has been incorrectly set.
Recommended Action The system is working properly and no action is required. If you want to
specify a smaller testing interval, the error message text provides the lowest possible configurable
interval for the specified monitoring interval.
Error Message DIAGMGR-5-MODULE_MISSING: Diagnostic command issued on non-existing
Module <[dec]>
Explanation A line card could not be located in a slot where a diagnostic action was requested.
Recommended Action Ensure the targeted line card is properly seated in the specified slot. If the line
card is properly seated, ensure the correct slot was indicated in the command-line interface. If the
line card is well-seated and the correct slot was specified, copy the error message exactly as it
appears on the screen as well as the output of show tech-support and paste the output into a separate
file. Contact your technical support representative with the gathered information.
Error Message DIAGMGR-5-NONHM_AS_HM: The Test <[chars]> cannot be used as health
monitoring test
Explanation Non-HM test cannot be scheduled to run as a Health Monitoring test.
Recommended Action No action is required.
DIAGMGR-6
Error Message DIAGMGR-6-BOOTUP_DIAG_OK: Module <[dec]>: Passed Online Diagnostics
Explanation The diagnostic tests did not detect any error on the card.
Recommended Action This is an informational message stating that the line card passed the
diagnostic tests.
Error Message DIAGMGR-6-BOOTUP_TEST_STARTED: Module <[dec]>: Running [chars]
Diagnostics
Explanation Starting bootup testing for above module.
Recommended Action No action is required.
DMM-SLOT# Messages
This section contains the DMM-SLOT# messages.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals