Send document comments to nexus7k-feedback-doc@cisco.com
2-167
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETHPORT Messages
Error Message ETH_PORT_SEC-5-ETH_PORT_SEC_DISABLED: eth_port_sec Disabled on
if_index:[hex]
Explanation The Eth_port_sec service has been disabled.
Recommended Action No action is required.
Error Message ETH_PORT_SEC-5-ETH_PORT_SEC_DYNAMIC_MAC_ADDRESS_CLEARED: Dynamic MAC
addresses for port [chars] cleared
Explanation The system has detected that a dynamic MAC address for the port has been cleared.
Recommended Action No action is required.
Error Message ETH_PORT_SEC-5-ETH_PORT_SEC_ENABLED: eth_port_sec Enabled on
if_index:[hex]
Explanation The Eth_port_sec Service has been enabled.
Recommended Action No action is required.
Error Message ETH_PORT_SEC-5-ETH_PORT_SEC_HOST_ADDITION: A new Host [chars] learnt
on Port [chars] in Vlan [dec]
Explanation A new host is learned on a port.
Recommended Action No action is required.
Error Message ETH_PORT_SEC-5-ETH_PORT_SEC_HOST_DELETION: Host [chars] bound to
secure port [chars] in Vlan [dec] has been removed
Explanation A host has been removed.
Recommended Action No action is required.
ETHPORT Messages
This section contains the ETHPORT messages.
ETHPORT-2
Error Message ETHPORT-2-IF_CRITICAL_FAILURE: (Debug syslog)Critical failure:
[chars], [chars]
Explanation There was a critical failure in the component.
Recommended Action Follow instructions on the syslog.