Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-276
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IPACL Messages
Error Message IP-6-STATS_ERROR Format: Failed to get hardware statistics for
interface %s, reason %s
Explanation IP could not get the requested statistics from the hardware.
Recommended Action No action is required.
Error Message IP-6-SYSMAN_CLEANUP Format: Terminated by SYSMAN cleanup signal %d
Explanation The system Manager sent a cleanup signal to IP to exit the process.
Recommended Action No action is required.
IPACL Messages
This section contains the IPACL messages.
IPACL-0
Error Message IPACL-0-EMERG: [chars]
Explanation Ipacl caused a system failure.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
IPACL-1
Error Message IPACL-1-ALERT: [chars]
Explanation Ipacl caused failures in other services.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
IPACL-2
Error Message IPACL-2-CRIT: [chars]
Explanation Ipacl encountered a catastrophic error.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English