Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-808
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
VRRP_CFG Messages
VRRP-ENG-6
Error Message VRRP-ENG-6-VSHA_RESULT: VR ID [dec] on interface [chars] state change
request result [chars]
Explanation The result of the request for status change on the virtual router (with VSHA extension)
specified is [chars].
Recommended Action No action is required.
VRRP_CFG Messages
This section contains the VRRP_CFG messages.
VRRP_CFG-2
Error Message VRRP_CFG-2-ALLOC_MEMORY: Memory allocation failed
Explanation The service failed to allocate a block of dynamic memory.
Recommended Action No action is required.
VRRP_CFG-3
Error Message VRRP_CFG-3-INIT_FAILED: Initialization failed. Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurred while
initializing the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
debug the specified component.
Error Message VRRP_CFG-3-VRRP_FEATURE_MANAGER_ERROR: Error in feature manager
operation
Explanation The feature manager operation had an error.
Recommended Action Check the reason for error using feature manager and fix the problem.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English