Send document comments to nexus7k-feedback-doc@cisco.com
2-68
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BOOTVAR Messages
Error Message BOOTVAR-2-AUTOCOPY_FAILED: Autocopy of file [chars] to standby
failed. [chars] (Error-id: [hex])
Explanation The image to be copied to standby vi the auto-copy feature failed.
Recommended Action Check error id for specified reason.
Error Message BOOTVAR-2-AUTOSYNC_FAILED: Image autosync failed. Reason: [chars]
([hex])
Explanation Image synchronization failed.
Recommended Action Check that there is enough space on the flash, and check the system high
availability status.
Error Message BOOTVAR-2-CONFIG_ERROR: Failed to update boot configuration
Explanation An error has occurred during the update of the boot configuration files.
Recommended Action Check that there is enough space on the flash, enter the show boot command
to check the configured image names, enter the show loader internal command to compare the
configurations, if the configurations do not match, enter the write erase command and retry saving
the configuration.
Error Message BOOTVAR-2-IMAGE_NOT_COMPATIBLE: Warning: image [chars] is not
compatible with the current platform in SUP [dec]
Explanation The input image name is not compatible with the current platform.
Recommended Action Make sure that the system has the correct image before you reboot.
BOOTVAR-3
Error Message BOOTVAR-3-AUTOCOPY_FAILED_STANDBY_FULL: Autocopy of file [chars] to
standby failed due to not enough disk space on standby
Explanation There is not enough disk space on the standby for the file to be copied.
Recommended Action Clear space on the standby disk.
Error Message BOOTVAR-3-INIT_FAILED: Initialization failed: Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurs during
initialization of the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
pay attention to the specified component.
To Next Page
Loading...
Need help?
General
