Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-521
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT-CHANNEL Messages
Error Message PORT-CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec])
Explanation Not enough memory.
Recommended Action No action is required.
Error Message PORT-CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for
[chars] [[chars]]
Explanation Parameter mapping failed.
Recommended Action Specified service has failed; check its status.
Error Message PORT-CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast [chars]:
[chars]
Explanation The system has failed to send a multicast message to all modules, usually because some
module went down.
Recommended Action Run show port channel consistency to check consistency.
PORT-CHANNEL-2
Error Message PORT-CHANNEL-2-AUTO_CREATE_DISABLED: [chars] has been deprecated;
[chars] [chars]
Explanation Auto create port channel is deprecated and disabled.
Recommended Action Convert the auto created channel to persistent by doing port channel <n>
persistent.
Error Message PORT-CHANNEL-2-RESET_MODULE: reset module [dec] for not responding or
returning error
Explanation A module is reset for not responding or returning error.
Recommended Action No action is required.
PORT-CHANNEL-3
Error Message PORT-CHANNEL-3-COMPAT_CHECK_FAILURE: [chars] is not compatible
Explanation Compatibility check failed when adding ports to port channel.
Recommended Action Make sure the compatibility parameters are consistent while adding ports to
port channel, or use force option.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English