Send document comments to nexus7k-feedback-doc@cisco.com
2-262
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IM Messages
ILC_HELPER-2
Error Message ILC_HELPER-2-NO_LICENSE_REBOOT: Linecard [dec] will reboot now.
Explanation SSE License has expired, therefore the line card will be rebooted.
Recommended Action Install appropriate SSE license to be able to use SSM features normally.
ILC_HELPER-3
Error Message ILC_HELPER-3-INVALID_BOOTVAR: Invalid [chars] boot variable
configured. The linecard will come online in L2 mode
Explanation The boot variable is misconfigured to a wrong image. So the line card will come online
in normal L2 mode instead of L3 mode.
Recommended Action Configure a proper image for the target boot variable.
Error Message ILC_HELPER-3-INVALID_SSI: [chars]
Explanation The ssi boot variable is configured to an invalid image. So, the line card will be brought
online in basic mode instead of advanced SSI mode.
Recommended Action Configure a proper image for the ssi boot variable.
ILC_HELPER-6
Error Message ILC_HELPER-6-LICENSE_VALID: A valid license for linecard [dec] has
been obtained
Explanation A valid license has been obtained for the SSM.
Recommended Action No action is required.
Error Message ILC_HELPER-6-UPGRADE_DELAY: The SSI upgrade on slot [dec] is delayed
by [dec] secs.
Explanation The SSI upgrade is delayed due to the configured ssm upgrade delay command.
Recommended Action No action is required.
IM Messages
This section contains the IM messages.