Send document comments to nexus7k-feedback-doc@cisco.com
2-329
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IVR Messages
Error Message IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices, failure reason code: [hex]
Explanation Failed to program FCID rewrite entries probably because the hardware ran out of FCID
rewrite entries. This can happen if there are too many devices in Inter-VSAN zone or too many local
VSANs in VSAN topology.
Recommended Action Reduce the number of devices involved in IVR in the active IVR zone set.
Also, reduce the number of redundant transit VSANs, if any.
Error Message IVR-2-DEVICE_STATE_INCOMPATIBLE_WITH_NAT_MODE: State for device with
port WWN [chars] could not be restored because it was incompatible with the current
NAT mode([dec]). This probably happened because NAT mode was modified without
completely deactivating the active IVR zoneset
Explanation This probably happened because NAT mode was modified without completely
deactivating the active IVR zone set.
Recommended Action The switch needs to be rebooted.
Error Message IVR-2-DEVICE_VSAN_REWRITE_FAILURE: Failure while programming VSAN
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices
Explanation Failed to program VSAN rewrite entries probably because the hardware ran out of
VSAN rewrite entries. This can happen if there are too many devices in Inter-VSAN zone or too
many local VSANs in VSAN topology.
Recommended Action Reduce the number of domains involved in IVR by moving the members of
active IVR zone set to fewer switches. Also, reduce the number of redundant transit VSANs, if any.
Error Message IVR-2-INTEROP_MODE_2_OR_3_BF_FAILED: [chars] VSAN [dec] Virtual
Domain [chars]
Explanation Build Fabric (BF) failed in VSAN [dec]. The BF was initiated in order to remove an
unused virtual domain [dec] from the fcdomain list in that VSAN. The virtual domain still remains
in the fcdomain list and therefore it would not be available in that VSAN for assignment.
Recommended Action Perform a manual build fabric using fcdomain's interface if you would like to
remove the unused virtual domain(s) from the fcdomain list.
To Next Page
Loading...
Need help?
General
