Send document comments to nexus7k-feedback-doc@cisco.com
2-156
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETH-PORT-SEC Messages
ETH-PORT-SEC-3
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_CONFIG_MAC_FAILED: Failed to configure
MACs
Explanation The system has failed to configure MAC addresses.
Recommended Action No action is required.
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_INVALID_VLAN: Invalid VLAN configuration
Explanation The system has detected an invalid VLAN configuration.
Recommended Action No action is required.
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_SECURITY_VIOLATION_ANOTHER_PORT: Host
[chars] bound to Port [chars] in Vlan [dec] is trying to access Port [chars] in
Vlan [dec]
Explanation The port is in a violation state because a MAC address that was seen on one port has
been seen on another port too.
Recommended Action No action is required.
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_SECURITY_VIOLATION_MAX_MAC_VLAN: Port
[chars] moved to [chars] state as host [chars] is trying to access the port in
vlan [dec]
Explanation The port is in a violation state due to an exceeding address count.
Recommended Action No action is required.
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_UNABLE_TO_DISABLE: Unable to disable
eth_port_sec [chars].
Explanation The system is unable to disable the eth_port_sec service.
Recommended Action No action is required.
Error Message ETH-PORT-SEC-3-ETH_PORT_SEC_UNABLE_TO_ENABLE: Unable to enable
eth_port_sec [chars].
Explanation The system is unable to enable the eth_port_sec service.
Recommended Action No action is required.