Send document comments to nexus7k-feedback-doc@cisco.com
2-674
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
SYSMGR-2
Error Message SYSMGR-2-BOOTSCOPE_HANDSHAKE: Service [chars] is in the boot scope,
but tried a regular handshake. Discarding request.
Explanation A service is trying to take actions that belong to a different class of services.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-2-CFGERASE_ABORTED: Write erase aborted.
Explanation Write erase has failed.
Recommended Action Verify the other syslog messages printed correct the problem, and try again.
Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED: Configuration snapshot aborted.
Explanation An attempt to save a snapshot of the startup-config has failed.
Recommended Action Verify the other syslog messages printed correct the problem, and try again.
Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED_DIR: Unable to open the configuration
directory. Aborting configuration snapshot.
Explanation The destination location for the snapshot-config could not be found.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.
Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED_INIT: Unable to initialize the
configuration directory (error-id [hex]). Aborting configuration snapshot.
Explanation An attempt to copy the startup-config to snapshot-config has failed because the old data
could not be removed.
Recommended Action If the problem persists, please use the vshboot command 'init system' to
initialize the configuration partition.
Error Message SYSMGR-2-CFGSYNC_FAILURE: Syncing of the configuration to the standby
failed.
Explanation Syncing of the configuration to the standby failed.
Recommended Action Verify the other syslog messages printed correct the problem, and try again.
To Next Page
Loading...
Need help?
General
