Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-610
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SMM Messages
Error Message SME_CPP-SLOT#-3-LOG_ERR_SME_NON_TAPE_MISCONFIG: A non-tape device
misconfigured under tape config - Device Name:[chars] Host PWWN:[chars] Tgt
PWWN:[chars] LUN Id:%Ld
Explanation A disk misconfigured under tape config.
Recommended Action No action is required.
SME_CPP-SLOT#-4
Error Message SME_CPP-SLOT#-4-LOG_WARN_SME_MAX_BLOCK_LEN: Maximum block length
[dec] of tape drive is 256K or less - [chars] LunID:[chars] VendorID:[chars]
ProdID:[chars] Serial Num:[chars] Cluster:[chars] Tape Device:[chars]
Explanation This tape drive may not operate correctly with SME.
Recommended Action No action is required.
SMM Messages
This section contains the SMM messages.
SMM-3
Error Message SMM-3-API_FAILED Format: %s failed in %s
Explanation A component API call has failed in SMM.
Recommended Action No action is required.
Error Message SMM-3-API_MTS_FAILED Format: %s failed in %s, errno: %s
Explanation SMM failed using the MTS API.
Recommended Action No action is required.
Error Message SMM-3-API_SM_FAILED Format: Could not allocate shared-memory segment.
%s failed in %s with error %s
Explanation SMM process could not allocate shared-memory.
Parameters: SM API, Function name, Error ...
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English