Send document comments to nexus7k-feedback-doc@cisco.com
2-391
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
MODULE Messages
MODULE-5
Error Message MODULE-5-ACTIVE_SUP_OK: Supervisor [dec] is active (serial: [chars])
Explanation Module [decimal digit] is ready to be configured and be able to switch traffic.
Recommended Action No action is required.
Error Message MODULE-5-LCM_MODULE_UPGRADE_END: Upgrade of module [dec] ended
Explanation An upgrade of the module has ended.
Recommended Action No action is required.
Error Message MODULE-5-LCM_MODULE_UPGRADE_START: Upgrade of module [dec] started
Explanation An upgrade of the module has been started by the installer.
Recommended Action No action is required.
Error Message MODULE-5-MOD_OK: Module [dec] is online (serial: [chars])
Explanation Module [decimal digit] is ready to be configured and be able to switch traffic.
Recommended Action No action is required.
Error Message MODULE-5-MOD_REINIT: Re-initializing module [dec] (serial: [chars])
Explanation Module [decimal digit] reported a failure during the initialization phase and will be
rebooted.
Recommended Action Collect information about the module by issuing the commands 'show
module_internal all module <module number>'.
Error Message MODULE-5-MOD_RESTART: Module [dec] is restarting after image download
Explanation Module [decimal digit] completed image download and is restarting.
Recommended Action No action is required.
Error Message MODULE-5-MOD_STARTUP_CFG_MISMATCH: The startup configuration cannot
be applied to a different module type for module [dec] (serial: [chars]). [chars]
module is replacing [chars].
Explanation The startup configuration for module [decimal digit] contains information about a
different type of module instead of containing information about the current one.
Recommended Action No action is required.
To Next Page
Loading...
