EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #428 background imageLoading...
Page #428 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-390
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
MODULE Messages
Error Message MODULE-2-XBAR_UNKNOWN: Xbar type [[dec]] in slot [dec] is not
supported
Explanation The software card id of xbar [decimal digit] is not supported by the supervisor.
Recommended Action Collect information about the module by issuing the commands 'show module
internal all xbar [decimal digit]'.
MODULE-3
Error Message MODULE-3-MOD_SRG_NOT_COMPATIBLE: Module [dec] (serial: [chars])
firmware is not compatible with supervisor, downloading new image
Explanation The software version of module [decimal digit] is not supported by the supervisor.
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
MODULE-4
Error Message MODULE-4-MOD_WARNING: Module [dec] (serial: [chars]) reported warning
[chars] due to [chars] in device [dec] (device error [hex])
Explanation Module [decimal digit] reported a warning in the runtime diagnostic due to failure in
some of the ports.
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
Error Message MODULE-4-MOD_WARNING: Module [dec] (serial: [chars]) reported
warnings on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec]
(device error [hex])
Explanation Module [decimal digit] reported a warning in the runtime diagnostic due to failure in
some of the ports.
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
Error Message MODULE-4-XBAR_WARNING: Xbar [dec] (serial: [chars]) reported warnings
on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device
error [hex])
Explanation Xbar [decimal digit] reported a warning in the runtime diagnostic due to failure in some
of the ports.
Recommended Action Collect information about the module by issuing the command 'show module
internal all xbar [decimal digit]'.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals