EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #427 background imageLoading...
Page #427 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-389
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
MODULE Messages
Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] (serial: [chars])
reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in
device [dec] (error [hex])
Explanation Module [decimal digit] reported a failure in the runtime diagnostic due to failure in
some of the ports.
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
Error Message MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not
supported
Explanation The software card id of module [decimal digit] is not supported by the supervisor.
Recommended Action Collect information about the module by issuing the commands 'show module
internal all module [decimal digit]'.
Error Message MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported
failure [chars] due to [chars] in device [dec] (device error [hex])
Explanation The xbar in slot [decimal digit] reported a failure in the runtime diagnostic. Module
manager is going to power cycle the module.
Recommended Action Collect information about the module by issuing the command 'show module
internal all xbar [decimal digit]'.
Error Message MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars])
failed
Explanation Xbar [decimal digit] reported a failure during the initialization phase and will be
powered down.
Recommended Action Collect information about the module by issuing the commands 'show
module_internal all xbar <module number>'.
Error Message MODULE-2-XBAR_SOMEPORTS_FAILED: Xbar [dec] (serial: [chars]) reported
failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec]
(error [hex])
Explanation Xbar [decimal digit] reported a failure in the runtime diagnostic due to failure in some
of the ports.
Recommended Action Collect information about the module by issuing the command 'show module
internal all xbar [decimal digit]'.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals