Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-790
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
VNI Messages
Error Message VNI-2-VNI_ALLOC_MEMORY: Memory allocation failed
Explanation The service failed to allocate a block of dynamic memory.
Recommended Action No action is required.
VNI-3
Error Message VNI-3-INIT_FAILED: Initialization failed. Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurred while
initializing the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
debug the specified component.
Error Message VNI-3-VNI_INIT_FAILED: Initialization failed. Component [chars]
Explanation The system has detected that the service has failed to start. The failure occurred while
initializing the component [chars].
Recommended Action Enter the show processes command to check the status of the other processes,
debug the specified component.
VNI-6
Error Message VNI-6-INTERFACE_EVENT: VSAN interface [chars] [chars]
Explanation The specified VSAN The system has detected that the interface has been successfully
[chars].
Recommended Action No action is required.
Error Message VNI-6-STARTING: Virtual Network Interface Manager started
Explanation The service has successfully started.
Recommended Action No action is required.
Error Message VNI-6-VNI_INTERFACE_EVENT: VSAN interface [chars] [chars]
Explanation The specified VSAN The system has detected that the interface has been successfully
[chars].
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English