Send document comments to nexus7k-feedback-doc@cisco.com
2-504
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT Messages
Error Message PORT-3-IF_TRANSCEIVER_READ_ERROR: Transceiver read error for
interface [chars]
Explanation Transceiver eeprom read failed.
Recommended Action Remove and insert the SFP back again. If the problem persists check if the
transceiver is supported using the command: show interface transceiver. Contact customer support
to resolve the condition.
Error Message PORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver for interface [chars]
is not supported
Explanation Transceiver is not from an authorized vendor.
Recommended Action This command will determine the transceiver being used: show interface
transceiver. Contact customer support for a list of authorized transceiver vendors.
PORT-4
Error Message PORT-4-IF_PORT_SECURITY_VIOLATION: Interface [chars] encountered port
security violation
Explanation The port has detected a port security violation.
Recommended Action Check the port security configurations on interface.
Error Message PORT-4-IF_SFP_CLK_RATE_ERROR: SFP clock rate error for interface
[chars]
Explanation The SFP clock rate has a mismatch or has failed.
Recommended Action Remove the SFP and insert a new one with a different frequency type. If the
problem persists check if the transceiver is supported using the command: show interface
transceiver. Contact customer support to resolve the condition.
Error Message PORT-4-IF_SFP_WARNING: Interface [chars], [chars]
Explanation There was a warning on the transceiver module.
Recommended Action Enter the show interface transceiver details command to obtain more
information.
Error Message PORT-4-IF_TRUSTSEC_VIOLATION: Interface [chars] encountered port
security violation
Explanation The port has detected a port security violation.
Recommended Action Check the port security configurations on interface.
To Next Page
Loading...
Need help?
General
