EasyManuals Logo
Home>Cisco>Switch>AP775A - Nexus Converged Network Switch 5010

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-130
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DOT1X Messages
Error Message DOT1X-4-MULTIHOST_ON_PCM: Interface [chars] is a member of
portchannel, dot1x host mode will be multi-host and changing it to single-host
mode won't be supported
Explanation Current Port is a member of port channel, so dot1x host mode has to be in multi-host
mode.
Recommended Action To change host mode, ensure that port is not a member of port channel.
Error Message DOT1X-4-STOPPED: Event [chars] ignored because the state machine is
stopped: [chars] [chars]
Explanation An attempt was made to post an event to a state machine that has already been stopped.
Recommended Action An internal error has occurred with the state machine. The traceback should
indicate the guilty party.
Error Message DOT1X-4-TO_MULTIHOST: Interface [chars] is in trunk mode, dot1x host
mode will be multi-host and changing it to single-host mode won't be supported
Explanation Current Port is in trunk mode, so dot1x host mode has to be in multi-host mode.
Recommended Action To change host mode, ensure that port is not in trunk mode.
DOT1X-5
Error Message DOT1X-5-DOT1X_DISABLED: dot1x Disabled
Explanation Dot1x service has been disabled.
Recommended Action No action is required.
Error Message DOT1X-5-DOT1X_ENABLED: dot1x Enabled
Explanation Dot1x service has been enabled.
Recommended Action No action is required.
Error Message DOT1X-5-INVALID_MAC: broadcast or multicast mac address) [chars] is
trying to authenticate.
Explanation Authentication using 802.1x is not allowed for zero, broadcast, and multicast source
MAC addresses.
Recommended Action Connect a Dot1x supported Host to the Dot1x enabled port.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals