Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-213
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FCSP-MGR Messages
FCS-4
Error Message FCS-4-BAD_CT_FRAME: Invalid FCS frame: [chars] received from [hex]
Explanation The system has detected an invalid FCS FC-CT frame with [chars] received from FC-ID
[hex].
Recommended Action No action is required.
FCS-5
Error Message FCS-5-API_FAIL: [chars]: [chars]
Explanation An API called by FCS failed. [chars] indicates the API name failed and [chars] the
reason for failure.
Recommended Action If this message is seen during a cold boot, it means that the queried module
came up after FCS and this case can be igored.
Error Message FCS-5-DB_NOTICE: [chars]
Explanation An error has occurred during an FCS database operation. [chars] indicates the reason
for the error.
Recommended Action No action is required.
FCS-6
Error Message FCS-6-INFORMATION: [chars]
Explanation An error has occurred that affects FCS. [chars] indicates the event.
Recommended Action No action is required.
Error Message FCS-6-REXMIT_PKT: Retransmitting request [chars] to domain [dec] in
VSAN [dec]
Explanation There was a retransmission of an FC2 request. [chars] indicates FCS request [dec]
indicates the remote domain and [dec] the VSAN ID.
Recommended Action No action is required.
FCSP-MGR Messages
This section contains the FCSP-MGR messages.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English