Send document comments to nexus7k-feedback-doc@cisco.com
2-275
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IP Messages
Error Message IP-6-IP_MTS_UNKNOWN_MSG Format: Received unknown MTS message with
opcde %d, dropping it
Explanation IP received an unknown message. The message is dropped.
Recommended Action No action is required.
Error Message IP-6-IP_UNK_MSG_MAJOR Format: Unrecognized message from %s. Major
type %d
Explanation An unknown message (major) was received from another process.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IP-6-IP_UNK_MSG_MINOR Format: Unrecognized message from %s. Minor
type %d
Explanation An unknown message (mior) was received from another process.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message IP-6-MQ_FLUSH Format: Flushing %d messages from the MRIB message queue
Explanation The MRIB message queue was flushed after a restart of the IP process.
Recommended Action No action is required.
Error Message IP-6-REG_SEND_MSG Format: Suppress PIM Data Register for (%s, %s) due
to suppression-timer\n
Explanation Suppress PIM Data Register due to suppression-timer.
Parameters: Source address, Group address ...
Recommended Action No action is required.
Error Message IP-6-ROUTE_NOT_ACTIVE: The [chars] is not active
Explanation The specified route is successfully configured but currently is not active.
Recommended Action Check that the route is correct and the outgoing interface is operationally up.
Error Message IP-6-STARTING: IP configuration Manager started
Explanation The IP Configuration Manager service has successfully started.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
