Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-170
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETHPORT Messages
Error Message ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver on interface
[chars] is not supported
Explanation The transceiver for the interface specified in the error message is not a Cisco supported
module.
Recommended Action Replace the module with a compatible transceiver. Contact the Cisco
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
Error Message ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER_VENDOR: Transceiver vendor
([hex] [hex] [hex]) for interface [chars] is not supported
Explanation The transceiver vendor for the interface specified in the error message is not supported.
Recommended Action Replace the module with a compatible transceiver. Contact the Cisco
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
ETHPORT-4
Error Message ETHPORT-4-IF_SFP_ALARM: Interface [chars], [chars]
Explanation There was an alarm on the transceiver module.
Recommended Action Enter the show interface transceiver details command to obtain more
information.
Error Message ETHPORT-4-IF_SFP_WARNING: Interface [chars], [chars]
Explanation There was a warning on the transceiver module.
Recommended Action Enter the show interface transceiver details command to obtain more
information.
ETHPORT-5
Error Message ETHPORT-5-IF_BANDWIDTH_CHANGE: Interface [chars],bandwidth changed to
[chars] Kbit
Explanation Bandwidth of the interface (port channel) has changed and this change is updated.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English