Send document comments to nexus7k-feedback-doc@cisco.com
2-169
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETHPORT Messages
ETHPORT-3
Error Message ETHPORT-3-IF_DOWN_CHANNEL_ERR_DISABLED: Interface [chars] is down
(Channel error disabled)
Explanation This interface belongs to a port channel and the port channel is error disabled.
Recommended Action Perform 'shut' and 'no shutdown' on the port channel interface that it belongs
to.
Error Message ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface [chars] is down (Error
disabled. Reason:[chars])
Explanation The system has detected that the interface has has detected an error during the
configuration.
Recommended Action Collect more information about the failed interface using the command 'show
port internal all interface [char]'. In most cases, you can recover using a 'shutdown' followed a 'no
shutdown' on the interface or remove and reinsert the fiber optic cable.
Error Message ETHPORT-3-IF_ERROR_VLANS_REMOVED: VLANs [chars] on Interface [chars]
are removed from suspended state.
Explanation The VLANs on an interface are being removed from the suspended state.
Recommended Action No action is required.
Error Message ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs [chars] on Interface
[chars] are being suspended. (Reason: [chars])
Explanation The VLANs on an interface are being suspended due to some protocol action.
Recommended Action No action is required.
Error Message ETHPORT-3-IF_SFP_ALARM: Interface [chars], [chars]
Explanation There was an alarm on the transceiver module.
Recommended Action Enter the show interface transceiver details command to obtain more
information.
Error Message ETHPORT-3-IF_SFP_ERROR: Interface [chars], [chars]
Explanation There was an error on the transceiver module.
Recommended Action Enter the show interface transceiver details command to obtain more
information.
To Next Page
Loading...
Need help?
General
